reason analysis and solution of visual dispensing machine redamp-ag亚洲国际厅

visual dispensing machine damp to do? what is the reason for the moisture return of the visual dispensing machine? most of them are due to the wrong place, which is greatly related to the natural environment, so it will return to tide. we generally put the automatic dispensing machine in a naturally ventilated area. if it is found that the ambient humidity on the humidity card exceeds 20%, it is confirmed that it is wet and cold. wet cold is a weather phenomenon, but sometimes it can be bad for goods. so if the visual dispensing machine is damp again, how to solve it? the following xinghua xiaobian will share with you the solution after the visual dispensing machine returns to tide.

in the usual waterproof work, it is best to put the automatic dispensing machine in the dry area, without being near the window, without immediately putting it in the soil, it is very important to eliminate the vertical drinking machine and its water resources, which can avoid the body moisture in the room, maintain the stable flow of gas and reduce room temperature are key. another, in order to improve the performance indicators, it is best to heat up before applying the visual dispensing machine. if it is not used often, it is best to cover the item well, and half a meter away from the road.

in particular, do not pull out the switching power supply of the visual dispensing machine. if the switching power supply is turned on after standby, it can ensure that the equipment is in a dry condition when it is not used at night. in the condition of wet and cold temperature, even if the automatic dispensing machine is not used, the switching power supply should be turned on and maintained dry.

if the long-term moisture, be sure to remove the wet source first, the best way for the visual dispensing machine moisture is to use electric heating blast drying oven to carry out baking, temperature control at 125 degrees celsius, baking time of about 20 hours.

check whether the role of the visual dispensing machine notes can be applied, especially in the case of serious sealing damage to the vulcanized rubber valve, there will be a situation of unclean strong glue. subsequently, the connection between the rubber valve and the mixing pipe is not tight, which is also one of the reasons for this situation. therefore, when the strong glue base terminates, use a utensil to catch the glue and then stand by until the strong glue does not seep, which is a very simple and very easy way to apply at this stage.